Displaying Radio Profile Information; Displaying Ap Status Information - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

WPA enabled:
authentication: 802.1X
vlan-name = orange
service-type = 2
multicast rate: AUTO
standard rates: 9.0,18.0,36.0,48.0,54.0
multicast rate: AUTO
standard rates: 5.5,11.0
multicast rate: AUTO 11g
standard rates: 6.0,9.0,12.0,18.0,24.0, 36.0,48.0,54.0

Displaying Radio Profile Information

To display radio profile information, use the following command:
show radio-profile {name | ?}
Entering show radio-profile ? displays a list of radio profiles.
To display radio profile information for the default radio profile, type the following command:
DWS-1008# show radio-profile default
Beacon Interval: 100
Max Tx Lifetime: 2000
RTS Threshold: 2346
Long Preamble: no
Tune Power: no
Tune Power Interval: 600
Channel Holddown: 300
Active-Scan: yes
WMM Powersave: no
No service profiles configured.

Displaying AP Status Information

To display status information including link state and switch status, use the following commands:
show ap status [terse] | [port-list | all [radio {1 | 2}]]
show dap status [terse] | [dap-num | all [radio {1 | 2}]]
The terse option displays a brief line of essential status information for each directly connected AP or
Distributed AP.
The all option displays information for all directly attached access points and all Distributed AP access
points configured on the switch.
D-Link DWS-1008 User Manual
ciphers: cipher-tkip
TKIP countermeasures time: 60000ms
session-timeout = 300
beacon rate: 6.0
mandatory rate: 6.0,12.0,24.0
beacon rate: 2.0
mandatory rate: 1.0,2.0
beacon rate: 2.0
mandatory rate: 1.0,2.0,5.5,11.0
DTIM Interval: 1
Max Rx Lifetime: 2000
Frag Threshold: 2346
Tune Channel: yes
Tune Channel Interval: 3600
Power ramp interval: 60
Countermeasures: none
RFID enabled: no
QoS Mode: wmm
1