Hardware Overview (Front Panel) - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Hardware Overview (Front Panel)

Console Port:
The serial console port provides a direct management connection to a DWS-1008 switch's
command-line interface (CLI). The port has a DB-9 female connector and supports the
EIA-232D signaling standard.
Ethernet Ports (1-6):
The 10/100 Ethernet ports on the DWS-1008 switch provide automatic MDI/MDX, which automatically
crosses over the send and receive signals if required. Ports 1-6 support PoE.
Uplink Ports (7 & 8):
Ports 7 and 8 on the DWS-1008 switch are uplink ports only and do not support PoE.
LEDS:
Link (1-8):
Solid green
Solid amber
Blinking green
Blinking amber
AP (1-6):
Solid green
Alternating green
and amber
Solid amber
Blinking amber
Unlit
D-Link DWS-1008 User Manual
100Mbps link is operational.
10Mbps link is operational.
Traffic is active on the 100Mbps link.
Traffic is active on the 10Mbps link.
For an DWL-8220AP's active link, with PoE enabled, all the following
are true:
• Access point has booted.
• Access point has received a valid configuration from the switch.
• Management link with an access point is operational.
Access point is booting with an image received from the switch.
If the LED remains in this state indefinitely, the boot or configuration
attempt has failed.
PoE is on but no access point is connected to the link.
Access point is not connected or is unresponsive, or there is a PoE
problem.
Port is not configured as an AP access port, or PoE is off.