D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 134

Parameter
cac-mode
cac-session
cipher-ccmp
cipher-tkip
cipher-wep 104
cipher-wep40
cos
dhcp-restrict
idle-client-probing
keep-initial-vlan
long-retry-count
no-broadcast
proxy-arp
psk-phrase
psk-raw
rsn-ie
shared-key-auth
short-retry-count
soda
D-Link DWS-1008 User Manual
Default Value
None
14
Disable
Enable
Disable
Disable
0
Disable
Enable
Disable
5
Disable
Disable
No Passphrase defined
No pre-shared key
defined
Disable
Disable
5
Disable
Radio Behavior When Parameter
Set To Default Value
Does not limit the number of active user sessions based on
Call Admission Control (CAC).
If session-based CAC is enabled (cac-mode is set to
session), limits the number of active user sessions on a
radio to 14.
Does not use Counter with Cipher Block Chaining Message
Authentication Code Protocol (CCMP) to encrypt traffic
sent to WPA clients.
When the WPA IE is enabled, uses Temporal Key Integrity
Protocol (TKIP) to encrypt traffic sent to WPA clients.
Does not use Wired Equivalent Privacy (WEP) with 104-bit
keys to encrypt traffic sent to WPA clients.
Does not use WEP with 40-bit keys to encrypt traffic sent
to WPA clients.
If static CoS is enabled (static-cos is set to enable), assigns
CoS 0 to all data traffic to or from clients.
Does not restrict a client's traffic to only DHCP traffic while
the client is being authenticated and authorized.
Sends a keepalive packet (a null-data frame) to each client
every 10 seconds.
Reassigns the user to a VLAN after roaming, instead of
leaving the roamed user on the VLAN assigned by the
switch where the user logged on.
Note: Enabling this option does not retain the user's initial
VLAN assignment in all cases.
Sends a long unicast frame up to five times without
acknowledgment.
Does not reduce wireless broadcast traffic by sending
unicasts to clients for ARP requests and DHCP Offers and
Acks instead of forwarding them as multicasts.
Does not reply on behalf of wireless clients to ARP requests
for client IP addresses. Instead, the radio forwards the ARP
Requests as wireless broadcasts.
Uses dynamically generated keys rather than statically
configured keys to authenticate WPA clients.
Uses dynamically generated keys rather than statically
configured keys to authenticate WPA clients.
Does not use the RSN IE intransmitted frames.
Does not use shared-key authentication.
This parameter does not enable PSK authentication for
WPA. To enable PSK encryption for WPA, use the set
radio-profileauth-psk command.
Sends a short unicast frame up to five times without
acknowledgment.
Sygate On Demand Agent (SODA) files are not downloaded
to connecting clients.
11