Displaying Ap Configuration Information - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Displaying AP Configuration Information

To display configuration information, use the following commands:
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
The command lists information separately for each access point.
To display configuration information for an access point on switch port 2, type the following command:
DWS-1008# show ap config 6
Port 6: AP model: DWL-8220AP, POE: enable, bias: high,
name: AP07 boot-download-enable: YES
force-image-download: NO load balancing group: none location: The conference room
contact: Bob the IT guy
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 1, profile: default auto-tune max-power: default,
Radio 2: type: 802.11a, mode: disabled, channel: dynamic tx pwr: 1, profile: default
auto-tune max-power: default,
To display configuration information for a Distributed AP access point configured on connection 1, type
the following command:
DWS-1008# show dap config 1
Dap 1: serial-id: 12345678, AP model: DWL-8220AP, bias: high,
name: DAP01 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
force-image-download: NO
load balancing group: none
location: The conference room
contact: Bob the IT guy
Radio 1: type: 802.11g, mode: disabled, channel: dynamic tx pwr: 1, profile: default
auto-tune max-power: default,
Radio 2: type: 802.11a, mode: disabled, channel: dynamic tx pwr: 1, profile: default
auto-tune max-power: default,
D-Link DWS-1008 User Manual 10