Displaying A Service Profile's Qos Settings - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Displaying a Service Profile's QoS Settings

To display QoS settings and all other settings for a service profile, use the following command:
show service-profile {name | ?}
The following example shows the configuration of the sp1 service profile.
DWS-1008# show service-profile sp1
ssid-name: corp2
Beacon: yes
DHCP restrict: no
Short retry limit: 5
Auth fallthru: none
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page:
Custom logout web-page:
Static COS: no
CAC mode: session
User idle timeout: 180
Keep initial vlan: no
Web Portal ACL:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
11a beacon rate: 6.0
11a mandatory rate: 6.0,12.0,24.0
11b beacon rate: 2.0
11b mandatory rate: 1.0,2.0
11g beacon rate: 2.0
11g mandatory rate: 1.0,2.0,5.5,11.0
Note: Configuration information for some settings appears in other chapters. To configure transmit
rates, or the long or short retry, see "Configuring a Service Profile". To configure the user-idle timeout
and idle-client probing, see "Displaying and Changing Network Session Timers".
D-Link DWS-1008 User Manual
ssid-type: crypto
Proxy ARP: no
No broadcast: no
Long retry limit: 5
Sygate On-Demand (SODA): no
Custom failure web-page:
Custom agent-directory:
COS: 0
CAC sessions: 14
Idle client probing: yes
Web Portal Session Timeout: 5
<none> WEP Key 2 value:
<none> WEP Key 4 value:
WEP Multicast Index:
multicast rate: AUTO
standard rates: 9.0,18.0,36.0,48.0,54.0
multicast rate: AUTO
standard rates: 5.5,11.0
multicast rate: AUTO
standard rates: 6.0,9.0,12.0,18.0,24.0, 36.0,48.0, 54.0
<none>
<none>
1
1