Setting Telnet Session Defaults; Changing The Current Telnet Session Defaults - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

For example, the following command sends all error-level event messages generated by a DWS-1008
switch to a server at IP address 192.168.153.09 and identifies them as facility 5 messages:
DWS-1008# set log server 192.168.153.09 severity error local-facility 5
success: change accepted.
To stop sending log messages to a syslog server, use the following command:
clear log server ip-addr
Session logging is disabled by default, and the event level is set to information (info) or higher. To
enable event logging to Telnet sessions and change the default event severity level, use the following
command:
set log sessions severity severity-level enable
To disable session logging, use the following command:
set log sessions disable

Changing the Current Telnet Session Defaults

By default, log information is not sent to your current Telnet session, and the log level is set to information
(info) or higher. To modify the severity of events logged to your current Telnet session, use the following
command from within the session:
set log current severity severity-level
To enable current session logging, type the following command:
DWS-1008# set log current enable
success: change accepted
To disable current session logging, type the following command:
DWS-1008# set log current disable
success: change accepted
D-Link DWS-1008 User Manual

Setting Telnet Session Defaults