Installation; Serial Console Cable; 10/100 Ethernet Cable Wiring - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Caution: The DWS-1008 switch has been designed and tested to be installed in an operating ambient
temperature of 0° C to +40° C (32° F to 104° F). To reduce the risk of equipment damage, install
equipment with consideration to these ambient conditions.
The serial console port has a female DB-9 connector and supports the EIA-232D signaling standard.
You need a standard DB-9-male-to-DB-9-female PC modem cable.
Connections on the 10/100 ports require CAT5 cable based on the EIA/TIA-586 standard. The 10/100
Ethernet ports on the DWS-1008 switch provide automatic MDI/MDX, which automatically crosses over
the send and receive signals if required.
The table below lists the pin signals for 10/100 Ethernet straight-through wiring. Pins 4, 5, 7, and 8 are
used only when Power over Ethernet (PoE) is enabled on the port. RD means Receive Data and TD
means Transmit Data.
Note: Mounting a DWL-8220AP access point on a solid surface requires CAT5 cable that does not have
strain relief. For installation on all other surfaces, you can use CAT5 cable with or without strain relief.
D-Link DWS-1008 User Manual

Installation

Serial Console Cable

Serial Console Pin Signals
Switch Pin Usage
2 Receive
3 Transmit
5 Ground

10/100 Ethernet Cable Wiring

DWS Switch
Pin Function
1 RD+
2 RD-
3 TD+
4 PoE+
5 PoE+
6 TD-
7 PoE-
8 PoE-
PC Pin Usage
3 Transmit
2 Receive
5 Ground
Other Device
Pin
1
2
3
4
5
6
7
8
Function
TD+
TD-
RD+
PoE+
PoE+
RD-
PoE-
PoE-