D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 157

Parameter
disabled
beacon-rate
multicast-rate auto
To change transmit rates for a service profile, use the following command:
set service-profile name transmit-rates {11a | 11b | 11g}
mandatory rate-list [disabled rate-list] [beacon-rate rate] [multicast-rate {rate | auto}]
The following command sets 802.11a mandatory rates for service profile sp1 to 6Mbps and 9 Mbps,
disables rates 48 Mbps and 54Mbps, and changes the beacon rate to 9 Mbps:
DWS-1008# set service-profile sp1 transmit-rates 11a mandatory 6.0,9.0
disabled 48.0,54.0 beacon-rate 9.0
success: change accepted.
D-Link DWS-1008 User Manual
Default Value
None. All rates applicable to the radio
type are supported by default.
• 11a - 6.0
• 11b - 2.0
• 11g - 2.0
for all radio types
Description
Data transmission rates that AP radios
will not use to transmit data. This setting
applies only to data sent by the AP
radios. The radios will still accept frames
from clients at disabled data rates.The
valid rates depend on the radio type
and are the same as the valid rates for
mandatory.If you disable a rate, you
cannot use the rate as a mandatory rate
or the beacon or multicast rate. All rates
that are applicable to the radio type and
that are not disabled are supported by
the radio.
Data rate of beacon frames sent by
AP radios. This rate is also used for
probe-response frames.The valid rates
depend on the radio type and are the
same as the valid rates for mandatory.
However, you cannot set the beacon
rate to a disabled rate.
Data rate of multicast frames sent by
AP radios.
• rate - Sets the multicast rate to a
specific rate. The valid rates depend
on the radio type and are the same as
the valid rates for mandatory. However,
you cannot set the multicast rate to a
disabled rate.
• auto - Sets the multicast rate to the
highest rate that can reach all clients
connected to the AP radio.
18