Ap Parameters - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

The ip and host keywords can be in lowercase, uppercase (IP or HOST), or mixed case (example: Ip,
Host, and so on.) You can use spaces after the colon or commas, but spaces are not supported within IP
addresses or hostnames. Leading zeroes are supported in IP addresses. For example, 100.130.001.1
is valid.
Valid characters in hostnames are uppercase and lowercase letters, numbers, periods ( . ), and hyphens
( - ). Other characters are not supported.
If you use the host option, you must configure the network's DNS server with address records that map
the hostnames in the list to the switch IP addresses.
After receiving a DHCP Offer containing a valid string for option 43, a Distributed AP sends a unicast
Find switch messages to each switch in the list.
No configuration is required on the switch itself.
The table below summarizes parameters that apply to individual access points, including dual-homing
parameters.
Parameter
Name
group
upgrade-firmware enable
location
contact
D-Link DWS-1008 User Manual

AP Parameters

Default Value
None
blink
disable
None
None
Description
Based on the port AP name. or
Distributed AP connection number.
For example: AP01 or DAP01
Named set of access points. MSS
load-balances user sessions among
the access points in the group.
Automatic upgrade of boot firmware.
LED blink mode - blinking LEDs on
an AP make the AP visually easy to
identify.
Information about the physical
location of an AP.
Contact information for the AP.
10