Assigning the Service Profile to Radios and Enabling the Radios
After you configure WPA settings in a service profile, you can map the service profile to a radio profile,
assign the radio profile to radios, and enable the radios to activate the settings.
To map a service profile to a radio profile, use the following command:
set radio-profile name service-profile name
To assign a radio profile to radios and enable the radios, use the following command:
set ap port-list radio {1 | 2} radio-profile name mode {enable | disable}
To map service profile wpa to radio profile bldg1, type the following command:
DWS-1008# set radio-profile blgd1 service-profile wpa
success: change accepted.
To assign radio profile bldg1 to radio 1 on ports 1-3, and 6 and enable the radios, type the following
command:
DWS-1008# set ap 1-3,5 radio 1 radio-profile bldg1 mode enable
success: change accepted.
To assign radio profile bldg1 to radio 2 on ports 1-3 and port 5 and enable the radios, type the following
command:
DWS-1008# set ap 1-3,5 radio 2 radio-profile bldg1 mode enable
success: change accepted.
D-Link DWS-1008 User Manual
1