Changing The Maximum Default Power Allowed On A Radio; Locking Down Tuned Settings - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Changing the Maximum Default Power Allowed On a Radio

By default, the maximum power level that RF Auto-Tuning can set on a radio is the same as the maximum
power level allowed for the country of operation. To change the maximum power level that RF Auto-
Tuning can assign, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune max-power power-level
The power-level can be a value from 1 to 20.
To set the maximum power that RF Auto-Tuning can set on radio 1 on the access point on port 1 to 12
dBm, type the following command.
DWS-1008# set ap 7 radio 1 auto-tune max-power 12
success: change accepted.

Locking Down Tuned Settings

You can convert dynamically assigned channels and power settings into statically configured settings,
by locking them down. When you lock down channel or power settings, MSS converts the latest values
set by RF Auto-Tuning into static settings.
You can lock down channel or power settings on a radio-profile basis. MSS implements the lock down
by changing the set {ap | dap} radio channel or set {ap | dap} radio tx-power command for each
radio managed by the radio profile.
To lock down channel or power settings, use the following commands:
set radio-profile name auto-tune channel-lockdown
set radio-profile name auto-tune power-lockdown
To verify the static settings, use the show {ap | dap} config command.
To save the locked down settings, you must save the switch's configuration.
The following commands lock down the channel and power settings for radios in radio profile rp2:
DWS-1008# set radio-profile rp2 auto-tune channel -lockdown
success: change accepted.
DWS-1008# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
D-Link DWS-1008 User Manual 18