In this example, two of the switch's ports, 1 and 6, have an operational status of up, indicating the links
on the ports are available. Ports 1 is network port and port 6 is an AP access port.
To display the PoE state of a port, use the following command:
show port poe [port-list]
To display PoE information for ports 1 and 4, type the following command:
DWS-1008# show port poe 1,4
Port
Name
==============================================
1
1
4
4
In this example, PoE is disabled on port 1 and enabled on port 4. The access point connected to port 4
is drawing 1.44 W of power from the switch.
To display port statistics, use the following command:
show port counters [octets | packets | receive-errors | transmit-errors | collisions |
receive-etherstats | transmit-etherstats] [port port-list]
You can specify one statistic type with the command. For example, to display octet statistics for port 3,
type the following command:
DWS-1008# show port counters octets port 3
Port
Status
=======================================
3
Up
Note: To display all types of statistics with the same command, use the monitor port counters
command.
D-Link DWS-1008 User Manual
Displaying PoE State
Link
Port
Status
Type config
down
AP
up
AP
Displaying Port Statistics
Rx Octets
27965420
PoE
PoE
Draw
disabled
off
enabled
1.44
Tx Octets
34886544