Verifying A Fingerprint On The Switch - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

If the AP is already installed and operating, use the show dap status command to display the
fingerprint.
The following example shows information for Distributed AP 8, including its fingerprint:
DWS-1008# show dap status 8
Dap: 8, IP-addr: 10.2.26.40 (vlan 'default'), AP model: DWL-8220AP, manufacturer: D-Link,
name: DAP08
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr id=0x29f1886d447f111a
ram=33554432 s/n=0424000779 hw_rev=A3
Uptime: 1 hours, 8 minutes, 17 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 1
operational power: 1 base mac: 00:0b:0e:0a:60:00
bssid1: 00:0b:0e:0a:60:00, ssid: public
bssid2: 00:0b:0e:0a:60:02, ssid: dlink
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 48 operational power: 11 base mac: 00:0b:0e:0a:60:01
bssid1: 00:0b:0e:0a:60:01, ssid: public
bssid2: 00:0b:0e:0a:60:03, ssid: dlink
The fingerprint is displayed regardless of whether it has been verified in MSS.
Note: The show dap config command lists an AP's fingerprint only if the fingerprint has been verified
in MSS. If the fingerprint has not been verified, the fingerprint info in the command output is blank.
To verify an AP's fingerprint on a switch, use the following command:
set dap num fingerprint hex
where hex is the 16-digit hexadecimal number of the fingerprint. Use a colon between each digit. Make
sure the fingerprint you enter matches the fingerprint used by the AP.
The following example sets the fingerprint for Distributed AP 8:
DWS-1008# set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
Note: A change to AP security support does not affect management sessions that are already established.
To apply the new setting to an AP, restart the AP.
D-Link DWS-1008 User Manual

Verifying a Fingerprint on the Switch

1