D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 79

4. Configure ports 3 and 4 as wired authentication ports and verify the configuration change.
Type the following commands:
DWS-1008# set port type wired-auth 3,4
success: change accepted
DWS-1008# show port status
Port Name
===============================================================
1 mgmt
2 finance
3 rsrch_dev
4 rsrch_dev
5 lobby
6 conf_room1 up
7 backbone
8 backbone
5. Configure ports 7 and 8 as a load-sharing port group to provide a redundant link to the
backbone, and verify the configuration change. Type the following commands:
DWS-1008# set port-group name backbonelink port 7,8 mode on
success: change accepted.
DWS-1008# show port-group
Port group: backbonelink is up
Ports: 7, 8
6. Add port 1 to the default VLAN (VLAN 1), configure a VLAN named roaming on ports 2 and
3, and verify the configuration changes. Type the following commands:
DWS-1008# set vlan default port 1
success: change accepted.
DWS-1008# set vlan 2 name roaming port 2-3
success: change accepted.
DWS-1008# show vlan config
VLAN Name
===============================================================
1 default
2 roaming
7. Save the configuration. Type the following command:
DWS-1008# save config
success: configuration saved.
D-Link DWS-1008 User Manual
Admin Oper Config
up up auto
up up auto
up up auto
up up auto
up up auto
up auto
up down auto
up down auto
Admin Status VLAN State Tunl Affin
Up Up
Up Up
Actual Type
100/full network
100/full ap
100/full wired auth 10/100BaseTx
100/full wired auth 10/100BaseTx
100/full ap
100/full ap
network
network
Port Port Tag
5
1 none
5
2 none
3 none
Media
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
State
Up
Up
Up
0