Supported Radius Attributes; Supported Standard And Extended Attributes - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Supported RADIUS Attributes

D-Link Mobility System Software (MSS) supports the standard and extended RADIUS authentication
and accounting attributes.
An attribute is sent to RADIUS accounting only if the table listing it shows Yes or Optional in the column
marked Sent in Accounting-Request for the attribute and the attribute is applied to the client's session
configuration. Attribute values have the following characteristics unless otherwise stated:
• Strings can contain a maximum of 253 characters.
• Integers are 4 bytes.
• IP addresses are 4 bytes.
The RADIUS attributes MSS supports are based on these IETF RFCs and drafts:
• RFC 2865, Remote Authentication Dial-in User Service (RADIUS)
• RFC 2866, RADIUS Accounting
• RFC 2868, RADIUS Attributes for Tunnel Protocol Support
• RFC 2869, RADIUS Extensions
• draft-congdon-radius-8021x-29.txt (IEEE 802.1X RADIUS Usage Guidelines)
Supported Standard and Extended
The RADIUS attributes shown in the table below are sent by DWS-1008 switches to RADIUS servers
during authentication and accounting.
Attribute
User-Name
User-Password
CHAP-Password
NAS-IP Address
D-Link DWS-1008 User Manual
Attributes
Rcv in Sent in
Type Access Access
Resp? Reqst?
1 No
2 No
3 No
4 No
Sent in
Acct
Reqst?
String. Name of the user to be authenticated.
Yes Yes
Used only in Request packets.
Password of the user to be authenticated,
Yes No
unless a CHAP-Password is used.
Password of the user to be authenticated,
Yes No
unless a User-Password is used.
Yes Yes IP address sent by the switch.
Description and Values