Adding An Arp Entry; Changing The Aging Timeout - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

MSS automatically adds a local entry for a switch and dynamic entries for addresses learned from traffic
received by the switch. You can add the following types of entries:
Dynamic - Ages out based on the aging timeout.
Static - Does not age out but is removed by a software reboot.
Permanent - Does not age out and remains in the ARP table following a software reboot.
To add an ARP entry, use the following command:
set arp {permanent | static | dynamic} ip-addr mac-addr
To add a static ARP entry that maps IP address 10.10.10.1 to MAC address 00:bb:cc:dd:ee:ff, type the
following command:
DWS-1008# set arp static 10.10.10.1 00:bb:cc:dd:ee:ff
success: added arp 10.10.10.1 at 00:bb:cc:dd:ee:ff on VLAN 1
The aging timeout specifies how long a dynamic entry can remain unused before the software removes
the entry from the ARP table. The default aging timeout is 1200 seconds (20 minutes). The aging
timeout does not affect the local entry, static entries, or permanent entries.
To change the aging timeout, use the following command:
set arp agingtime seconds
You can specify from 0 to 1,000,000 seconds. To disable aging, specify 0.
For example, to disable aging of dynamic ARP entries, type the following command:
DWS-1008# set arp agingtime 0
success: set arp aging time to 0 seconds
Note: To reset the ARP aging timeout to its default value, use the set arp agingtime 1200 command.
D-Link DWS-1008 User Manual

Adding an ARP Entry

Changing the Aging Timeout

8