Quickstart Example - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

4. Press Enter at the Enter password prompt.
5. Type quickstart. The command asks you a series of questions. You can type ? for more help. To
quit, press Ctrl+C.
One of the questions the script asks is the country code. For a list of valid country codes, see "Specifying
the Country of Operation".
Another question the script asks is, "Do you wish to configure wireless?" If you answer y, the script goes
on to ask you for SSID and user information, for unencrypted and encrypted SSIDs. If you answer n, the
script generates a key pair for SSH and then ends.
This example configures the following parameters:
• System name: DWS-1008-mrktg
• Country code (regulatory domain): US
• System IP address: 172.16.0.21, on IP interface 172.16.0.21 255.255.255.0
Note: The quickstart script asks for an IP address and subnet mask for the system IP address,
and converts the input into an IP interface with a subnet mask, and a system IP address that
uses that interface. Likewise, if you configure this information manually instead of using the
quickstart command, you must configure the interface and system IP address separately.
• Default route: 172.16.0.20
• Administrative user mxadmin, with password letmein. The only management access the switch
allows by default is CLI access through the serial connection.
• System Time and date parameters:
• Date: 31st of March, 2006
• Time: 4:36 PM
• Timezone: PST (Pacific Standard Time), with an offset of -8 hours from Universal Coordinated
Time (UTC)
• Unencrypted SSID name: public
• Username user1 and password pass1 for WebAAA
• Encrypted SSID name: corporate
• Username bob and password bobpass for 802.1X authentication
• Directly connected access point on port 2, model DWL-8220AP
The IP addresses, usernames, and passwords in this document are examples. Use values that are
appropriate for your organization.
If you configure time and date parameters, you will be required to enter a name for the timezone, and
then enter the value of the timezone (the offset from UTC) separately. You can use a string of up to 32
alphabetic characters as the timezone name.
D-Link DWS-1008 User Manual

Quickstart Example