D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 334

8 port 10/100 wireless switch with power over ethernet
Hide thumbs Also See for DWS-1008 - AirPremier MobileLAN Switch:
Table of Contents

Advertisement

Attribute
service-type
session-timeout
(network access mode
only)
ssid
(network access mode
only)
start-date
D-Link DWS-1008 User Manual
Description
Type of access the user is
requesting.
Maximum number of seconds
for the user's session.
SSID the user is allowed to
access after authentication.
Date and time at which the
user becomes eligible to
access the network. MSS
does not authenticate the user
unless the attempt to access
the network occurs at or after
the specified date and time,
but before the end-date (if
specified).
Valid Value(s)
One of the following numbers:
• 2—Framed; for network user access
• 6—Administrative; for administrative access to the switch,
with authorization to access the enabled (configuration)
mode. The user must enter the enable command and the
correct enable password to access the enabled mode.
• 7—NAS-Prompt; for administrative access to the
nonenabled mode only.
In this mode, the user can still enter the enable command
and the correct enable password to access the enabled
mode. For administrative sessions, the switch always sends
6 (Administrative). The RADIUS server can reply with one of
the values listed above. If the service-type is not set on the
RADIUS server, administrative users receive NAS-Prompt
access, and network users receive Framed access.
Note: MSS will quietly accept Callback Framed but you
cannot select this access type in MSS.
Number
between
0
(approximately 136.2 years).
Note. If the global reauthentication timeout (set by the set
dot1x reauth-period command) is shorter than the session-
timeout, MSS uses the global timeout instead.
Name of the SSID you want the user to use. The SSID must
be configured in a service profile, and the service profile
must be used by a radio profile assigned to D-Link radios in
the network.
Date and time, in the following format:
YY/MM/DD-HH:MM
You can use start-date alone or with end-date. You also can
use start-date, end-date, or both in conjunction with time-
of-day.
and
4,294,967,296
seconds
1

Advertisement

Table of Contents
loading

Table of Contents