Command Examples; Enabling The Snmp Service; Displaying Snmp Information; Displaying Snmp Version And Status Information - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

The following command configures a notification target for acknowledged notifications:
DWS-1008# set snmp notify target 1 10.10.40.9 usm inform
user securesnmpmgr1 snmp-engine-id ip
success: change accepted.
This command configures target 1 at IP address 10.10.40.9. The target's SNMP engine ID is based on
its address. The MSS SNMP engine will send notifications based on the default profile, and will require
the target to acknowledge receiving them.
The following command configures a notification target for unacknowledged notifications:
DWS-1008# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
To enable the MSS SNMP service, use the following command:
set ip snmp server {enable | disable}
The following command enables the SNMP service:
DWS-1008# set ip snmp server enable
success: change accepted.

Displaying SNMP Information

You can display the following SNMP information:
• Version and status information
• Configured community strings
• User-based security model (USM) settings
• Notification targets
• SNMP statistics counters

Displaying SNMP Version and Status Information

To display SNMP version and status information, use the following command:
show snmp status
D-Link DWS-1008 User Manual

Command Examples

Enabling the SNMP Service

100