Enabling Dynamic Wep In A Wpa Network - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

5. Display the service profile wpa to verify the changes. Type the following command:
DWS-1008# show service-profile sp1
6. Map service profile wpa to radio profile rp1. Type the following commands:
DWS-1008# set radio-profile rp1 service-profile wpa
success: change accepted.
7. Apply radio profile rp1 to radio 1 on port 4 and to radios 1 and 2 on port 6, enable the
radios, and verify the configuration changes. Type the following commands:
DWS-1008# set ap 4,6 radio 1 radio-profile rp1 mode enable
success: change accepted.
DWS-1008# set ap 11 radio 2 radio-profile rp1 mode enable
success: change accepted.
DWS-1008# show ap config
8. Save the configuration. Type the following command:
DWS-1008# save config
success: configuration saved.

Enabling Dynamic WEP in a WPA Network

The following example shows how to configure MSS to provide authentication and encryption for 801.X
dynamic WEP clients, and for 801.X WPA clients using TKIP. This example assumes that pass-through
authentication is used for all users. The commands are the same as those in "Enabling WPA with TKIP",
with the addition of a command to enable a WEP cipher suite. The WEP cipher suite allows authentication
and encryption for both WPA and non-WPA clients that want to authenticate using dynamic WEP.
1. Create an authentication rule that sends all 802.1X users of SSID mycorp in the EXAMPLE
domain to the server group shorebirds for authentication. Type the following command:
DWS-1008# set authentication dot1x ssid thiscorp EXAMPLE\* pass-through
shorebirds
2. Create a service profile named wpa-wep for the SSID. Type the following command:
DWS-1008# set service-profile wpa-wep
success: change accepted.
D-Link DWS-1008 User Manual 11