Resetting A Radio To Its Factory Default Settings; Restarting An Ap; Displaying Ap Information - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Resetting a Radio to its Factory Default Settings

To disable an AP radio and reset it to its factory default settings, use the following command:
clear {ap port-list | dap dap-num} radio {1 | 2 | all}
This command performs the following actions:
• Sets the transmit power, channel, and external antenna type to their default values.
• Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE setting.
To disable and reset radio 2 on the access point connected to port 3, type the following command:
DWS-1008# clear ap 3 radio 2
To restart an access point, use the following command:
reset {ap port-list | dap dap-num}
Use the reset ap command to reset an access point configured on an access port. Use the reset dap
command to reset a Distributed AP.
When you enter one of these commands, the access point drops all sessions and reboots.
Caution: Restarting an access point can cause data loss for users who are currently associated with
the AP.

Displaying AP Information

You can display the following AP information:
• AP and radio-specific configuration settings
• Connection information for Distributed APs configured on a switch
• List of Distributed APs that are not configured on a DWS-1008 switch
• Connection information for Distributed APs
• Service profile information
• Radio profile information
• Status information
• Information about static IP addresses on Distributed APs
• Statistics counters
D-Link DWS-1008 User Manual

Restarting an AP

1