Removing A Radio Profile; Configuring Radio-Specific Parameters; Configuring The Channel And Transmit Power - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

All radios that use this profile must be disabled before you can delete the profile. If you specify a
parameter, the setting for the parameter is reset to its default value. The settings of the other parameters
are unchanged and the radio profile remains in the configuration. If you do not specify a parameter, the
entire radio profile is deleted from the configuration.
To disable the radios that are using radio profile rp1 and reset the beaconed-ssid parameter to its
default value, type the following commands:
DWS-1008# set radio-profile rp1 mode disable
DWS-1008# clear radio-profile rp1 beaconed-ssid
success: change accepted.
To remove a radio profile, use the following command:
clear radio-profile name
Note. You must disable all radios that are using a radio profile before you can remove the profile.
To disable the radios that are using radio profile rptest and remove the profile, type the following
commands:
DWS-1008# set radio-profile rptest mode disable
DWS-1008# clear radio-profile rptest
success: change accepted.

Configuring Radio-Specific Parameters

This section shows how to configure the channel and transmit power on individual radios, and how to
configure for external antennas.

Configuring the Channel and Transmit Power

To set the channel and transmit power of a radio, use the following commands:
set {ap port-list | dap dap-num} radio {1 | 2} channel channel-number
set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level
The parameters are shown in separate commands for simplicity. However, you can use the channel and
tx-power parameters on the same command line. Specify 1 or 2 for the radio number:
• For a single-radio model, specify radio 1.
• For the 802.1 1b/g radio in a two-radio model, specify radio 1.
• For the 802.1 1a radio in a two-radio model, specify radio 2.
Note: The maximum transmit power you can configure on any D-Link radio is the highest setting allowed
for the country of operation or the highest setting supported on the hardware, whichever is lower.
D-Link DWS-1008 User Manual

Removing a Radio Profile

1