DES-3228PA Embedded Web System User Guide
Restoring Factory Default QoS Interface Settings
1.
Click Basic Setup > Quality of Service > Global Parameters > CoS. The CoS Global Parameters Page
opens.
2.
Select an interface by clicking the Default CoS from Incoming traffic field.
3.
Check the Restore Defaults checkbox.
4.
Click
. The factory defaults are restored on the interface.
Configure Bandwidth Settings
The Bandwidth Settings Page allows network managers to define the bandwidth settings for a specified egress
interface. Modifying queue scheduling affects the queue settings globally.
Queue shaping can be based per queue and/or per interface. Shaping is determined by the lower specified value.
The queue shaping type is selected in the Bandwidth Settings Page. To define bandwidth settings:
1.
Click Basic Setup > Quality of Service > Global Parameters > Bandwidth. The Bandwidth Settings Page
opens:
Figure 106: Bandwidth Settings Page
The Bandwidth Settings Page contains the following fields:
•
Unit no — Indicates the stacking members for which the bandwidth settings are displayed.
•
Interface — Indicates the Interface that is being displayed
•
Ingress Rate Limit — Indicates the Ingress traffic limit for the port.
–
Status — Indicates the traffic limit status.
Page 171