Restoring Factory Default Qos Interface Settings - D-Link Web Smart DES-3252P Install Manual

Figure 123:CoS Global Parameters Page
The CoS Global Parameters Page contains the following:
•
CoS Mode — Enables CoS Mode on the interface. The possible CoS Mode values are:
–
Disable — Disables CoS Mode on the interface.
–
Basic Mode — Enables Basic CoS Mode on the interface.
–
Advanced Mode — Enables Advanced CoS Mode on the interlace.
•
Interface — Displays the port or LAG for which the CoS details are displayed.
•
VLAN Priority Tag — Determines the default CoS value for incoming packets for which a VLAN tag is not
defined. The possible field values are 0-7. The default CoS is 0.
•
Restore Defaults — Restores the selected interface to the default configuration.
2. Select the CoS Mode field.
3. Define the Default CoS for Incoming Traffic field.
4. Click . CoS is enabled on the device.

Restoring Factory Default QoS Interface Settings

1. Click Basic Setup > Quality of Service > Global Parameters > CoS. The CoS Global Parameters Page
opens.
2. Select an interface by clicking the Default CoS from Incoming traffic field.
3. Check the Restore Defaults checkbox.
4. Click . The factory defaults are restored on the interface.
Page 190
Configuring Quality of Service
Defining General QoS Settings