Static/Default Route Settings - D-Link DGS-3312SR Release 3.5 Manual

Static/Default Route Settings

Static routes that have been previously configured appear in the Static/Default Route Settings table. To add a new route,
click on the Add button, a new window appears. To remove an existing route, click the X button in the Delete column for
the route you want to eliminate. To modify an existing entry, click the Modify button in the Static/Default Route Settings
window, which will bring up the identical window as the Add window.
Use the Static/Default Route Settings – Add window to configure IP settings and Metric cost for the new route.
Configure the IP settings for the new static route and click the Apply button to create the static route. The new route will
appear in the previous window. To view the new route and any other static routes configured for the Switch click the
All Static/Default Route Entries
The following fields can be set or viewed for windows of the Static/Default route Settings section:
Parameter
IP Address
Subnet Mask
Gateway
Hops/Cost
Protocol
Backup State
Delete
DGS-3312SR Stackable Gigabit Layer 3 Switch
Figure 5- 8. Static/Default Route Settings window
Figure 5- 9. Static/Default Route Settings – Add window
link.
Description
The IP address of the Static/Default Route.
The corresponding Subnet Mask of the IP address entered into the table.
The corresponding Gateway of the IP address entered into the table.
Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Click the X if you would like to delete this entry from the Static/Default Route Settings
table.
119
Show