Dell PowerConnect 5524P User Manual page 679

Single Policers
Defining Aggregate Policers Using CLI Commands
The following table summarizes the CLI commands for setting the fields in
the Aggregate Policer pages.
Table 22-15. Aggregate Policer CLI Commands
CLI Command
qos aggregate-policer
aggregate-policer-name
committed-rate-kbps excess-
burst-byte[exceed-action
{drop|policed-dscp-transmit}]
no qos aggregate-policer
aggregate-policer-name
The following is an example of the CLI commands:
console(config)# qos aggregate-policer policer1 124000
9600 exceed-action drop
Single policers are created by:
1 Create a policy in the Police Table pages
2 Configure the policy in the Policy Class Maps pages. Here the policy class
can be designated as containing a single policer, or it can be designated as
containing Aggregate policers.
Policy Table
A policy can consist of one of the following:
• One or more class maps of ACLs that define the traffic flows in the policy.
• One or more aggregate policers that apply the QoS to the traffic flows in
the policy.
Description
Defines the policer parameters that can
be applied to multiple traffic classes
within the same policy map.
Use the no form of this command to
remove an existing aggregate policer.
Dell PowerConnect 55xx Systems User Guide
679