Dell PowerConnect 5524P User Manual page 241

– IPv6 Address Type — When the server supports IPv6, this specifies
the type of static address supported. The possible options are:
• Link Local — A Link Local address that is non-routable and used
for communication on the same network only.
Global — A globally unique IPv6 address; visible and reachable
•
from different subnets.
– Link Local Interface — When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. The possible options
are:
• VLAN — The VLAN on which the IPv6 interface is configured.
• ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
• Host Name (1-160 Characters) — Enter the host name to be
associated with the IP address entered below.
• IP Address — Enter the IP address of the domain. Four addresses can
be entered.
4 Click Remove to delete a host name. All addresses for this host name are
deleted at the same time.
Mapping IP Addresses to Domain Host Names Using the CLI Commands
The following table summarizes the CLI commands for mapping domain
host names to IP addresses.
Table 9-35. Domain Host Name CLI Commands
CLI Command
ip host name address
[address2 address3
address4]
no ip host name
clear host {name|*}
show hosts [name]
Description
Defines the static host name-to-address mapping in
the host cache
Removes the name-to-address mapping.
Deletes entries from the host name-to-address cache.
Displays the default domain name, list of name server
hosts, the static and the cached list of host names and
addresses.
Dell PowerConnect 55xx Systems User Guide
241