Dell PowerConnect 5524P User Manual page 414

Configuring Port Mirroring Using CLI Commands
The following table summarizes the CLI commands for configuring Port
Mirroring.
Table 10-11. Port Mirroring CLI Commands
CLI Command
port monitor src-
interface-id [rx|tx]
no port monitor src-
interface-id
show ports monitor
The following is an example of the CLI commands:
console(config)# interface gi1/0/1
console(config-if)# port monitor gi1/0/8
console# show ports monitor
Source port Destination Port
----------- ----------------
gi1/0/1
414
Dell PowerConnect 55xx Systems User Guide
gi1/0/8
Description
Starts a port monitoring session. This must
be performed in Interface Configuration
mode, which is the destination interface.
Use the no form of this command to stop a
port monitoring session.
Displays the port monitoring status.
Type
----
RX,TX
Status
-----------
Active