Dell PowerConnect 5524P User Manual page 355

– Active Image — The name of the image file that is currently active on
the unit in the stack.
– After Reset — The image file that will be active on the unit in the
stack after the device is reset. The possible options are:
Image 1 — Activates Image file 1 after the device is reset.
•
• Image 2 — Activates Image file 2 after the device is reset.
2 Click Apply to select the image file to be used after reset in After Reset.
Working with the Active Image File Using CLI Commands
The following table summarizes the CLI commands for viewing fields
displayed in the Active Images
Table 9-66. Active Image CLI Commands
CLI Command
boot system {image-
1|image-2} [switch
number|all]
show version [unit
unit]
The following is an example of the CLI commands:
console# boot system image-1 all
Copy Files
Firmware and configuration files can be copied between units in the stack.
Use the Copy Files page to perform the following:
• Copy the firmware on the Master unit to another unit in the stack.
• Copy the master Running Configuration file to the master sTartup
Configuration file, or copy the configuration to a user-defined
configuration file.
• Copy the master Startup Configuration file to a backup file on the Flash
file system or to a USB if available.
.
Description
Sets the system image that the device loads at
startup.
Displays version information for the system
Dell PowerConnect 55xx Systems User Guide
355