Dell PowerConnect 5524P User Manual page 161

Table 9-4. Power Over Ethernet CLI Commands (Continued)
CLI Command
power inline priority
{critical|high|low}
no power inline priority
power inline usage-threshold
no power inline usage-
threshold
power inline traps enable
no power inline traps enable
power inline limit-mode
{class|port}
no power inline limit-mode
show power inline
[[[gigabitethernet|tengigabi
tethernet]port-number|vlan
vlan-id|port-channel LAG-
number]|module stack-member-
number]
The following is an example of the CLI commands:
console# show power inline
Unit Power Nominal Power
---- ------- ------------- ------------------ ---------------
1 Off
2 Off
3 Off
4 Off
Consumed Power
1 Watts 0 Watts (0%)
1 Watts 0 Watts (0%)
1 Watts 0 Watts (0%)
1 Watts 0 Watts (0%)
Dell PowerConnect 55xx Systems User Guide
Description
Configures the priority of the interface
from the point of view of inline power
management.
Use the no form of this command to
restore the default configuration.
Configures the threshold for triggering
alarms.
Use the no form of this command to
restore the default configuration.
Enables PoE device traps.
Use the no form of this command to
disable traps.
Sets the power limit mode of the system.
Use the no form of this command to
return to default.
Displays PoE configuration information
for all interfaces or for a unit in the stack.
Usage Threshold
95
95
95
95
Traps
-----
Disable
Disable
Disable
Disable
161