Dell PowerConnect 5524P User Manual page 205

The previously-assigned IP addresses are displayed.
2 To add an IP address to an interface, click Add, and enter the fields:
– IP Address — Enter the IP address assigned to the interface.
– Network Mask — Select the subnetwork mask to which traffic can be
routed.
– Prefix Length — Enter the number of bits that comprise the IP
address prefix of the subnetwork.
– Interface — Select the interface for which the IP address is defined.
Select an interface type Port, LAG, or VLAN and the specific
interface number.
Defining IPv4 Interfaces Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the IPv4 Interfaces Parameters page.
Table 9-18. IPv4 Interface Parameters CLI Commands
CLI Command
ip address ip-address
{mask|prefix-length}
no ip address [ip-address]
show ip interface
[[gigabitethernet|tengigabitet
hernet]port-number|vlan vlan-
id|port-channel LAG-number]
Description
Sets an IP address.
Use the no form of the command to
remove an IP address.
Displays the usability status of
interfaces configured for IP .
Dell PowerConnect 55xx Systems User Guide
205