Dell PowerConnect 5524P User Manual page 226

Table 9-29. ISATAP Tunnel CLI Commands (Continued)
CLI Command
tunnel isatap query-interval
seconds
no tunnel isatap query-interval
tunnel isatap solicitation-
interval seconds
no tunnel isatap solicitation-
interval
tunnel isatap robustness number
no tunnel isatap robustness
show ipv6 tunnel
The following is an example of a CLI script to create a tunnel:
Table 9-30. ISATAP Tunnel CLI Script
CLI Command
console#config
console(config)# interface vlan 1
console(config-if)# ip address
10.5.225.40 /27
console(config-if)# ip default-gateway
10.5.225.33
console(config-if)#exit
226
Dell PowerConnect 55xx Systems User Guide
Description
Configures the interval between DNS
Queries (before the IP address of the
ISATAP router is known) for the
automatic tunnel router domain
name.
Use the no form of this command to
restore the default configuration.
Configures the interval between
ISATAP router solicitations messages
(when there is no active ISATAP
router).
Use the no form of this command to
restore the default configuration.
Configures the number of DNS
Query/Router Solicitation refresh
messages that the device sends.
Use the no form of this command to
restore the default configuration.
Displays information on the ISATAP
tunnel.
Description
Enter Global Configuration
mode.
Enter Interface mode for
VLAN 1.
Configure an IP address with
prefix length of 27.
Set the address of the default
gateway and exit Interface
mode.