Dell PowerConnect 5524P User Manual page 219

The following is a sample script to configure IPv6 using CLI:
Table 9-27. Sample CLI Script to Configure IPv6 on a Port
CLI Command
console#config
console(config)# interface vlan 1
console(config-if)# ipv6 enable
console(config-if)# ipv6 address
5::1/64
IPv6 Default Gateway
Use the IPv6 Default Gateway pages to configure and view the default IPv6
router addresses. This list contains routers that are candidates to become the
switch default router for non-local traffic. The switch randomly selects a
router from the list. The switch supports one static IPv6 default router.
Dynamic default routers are routers that have sent router advertisements to
the switch IPv6 interface.
When adding or deleting IP addresses, the following events occur:
• When removing an IP interface, all of its default gateway IP addresses are
removed.
• Dynamic IP addresses cannot be removed.
• An alert message is displayed after a user attempts to insert more than one
IP address.
• An alert message is displayed when attempting to insert a non-Link Local
type address.
Dell PowerConnect 55xx Systems User Guide
Description
Enter Global Configuration
mode.
Enter VLAN mode for VLAN
1.
Enable IPv6 (dynamic).
Set the IPv6 address (static)
219