Dell PowerConnect 5524P User Manual page 514

2 Select a VLAN and enter the Multicast group IP address in Bridge
Multicast Address.
Two rows of ports and LAGs are displayed: for each unit
Static — Displays available static ports/LAGs. These port/LAGs can
–
be included or excluded from the Multicast groups, as described
below.
– Current — Displays status of ports/LAGs in the Multicast group, as
actually applied.
3 For each port in the VLAN, toggle to S to join the port to the selected
Multicast group as a static port. Toggle a port to F to indicate that it is
Forbidden to this group. Leave the field empty if it is not involved in the
VLAN.
4 To add a new Multicast group, click Add, and enter the fields:
– VLAN ID — Select the VLAN ID to set its forwarding method.
– New Bridge IP Multicast — Enter a Multicast group IP address.
New Bridge MAC Multicast — Enter a Multicast group MAC
–
address.
– Ports — Select the ports to be added to a Multicast service. Toggle a
port to S to join the port to the selected Multicast group as a static
port. Toggle a port to F to indicate that it is Forbidden to this service.
Leave the field empty if it is not involved in the VLAN.
– LAGs — Select the LAGs to be added to a Multicast service. Toggle a
LAG to S to join the port to the selected Multicast group as a static
LAG. Toggle a port to F to indicate that it is Forbidden to this service.
Leave the field empty if it is not involved in the VLAN.
The following table describes the codes used for the interface in this page:
Table 16-2. IGMP Port/LAG Members Table Control Settings
Port Control Definition
S Attaches the port to the Multicast group as static member in the static row.
The port/LAG has joined the Multicast group statically in the current row.
F Forbidden. The port cannot belong to the Multicast group.
Blank The port is not attached to a Multicast group, but it is also not forbidden.
514
Dell PowerConnect 55xx Systems User Guide