Dell PowerConnect 5524P User Manual page 110

Configuring IP-based ACEs Using CLI Commands
The following table summarizes the CLI commands for configuring I P-based
.
ACLs
Table 8-5. IP-Based ACE CLI Commands
CLI Command
permit protocol {any|source-ip-address
source-wildcard} {any|destination-ip-
address destination-wildcard} [dscp
number|precedence number] [time-range
time-range-name]
permit icmp {any|source-ip-address source-
wildcard} {any|destination-ip-address
destination-wildcard} [any|icmp-
type][any|icmp-code]] [dscp
number|precedence number] [time-range
time-range-name]
permit igmp {any|source-ip-address source-
wildcard} {any|destination-ip-address
destination-wildcard}[igmp-type] [dscp
number|precedence number] [time-range
time-range-name]
permit tcp {any|source-ip-address source-
wildcard} {any|source-port/port-
range}{any|destination-ip-address
destination-wildcard} {any|destination-
port/port-range } [dscp number|precedence
number] [match-all list-of-flags] [time-
range time-range-name]
permit udp {any|source-ip-address source-
wildcard} {any|source-port|port-range}
{any|destination-ip-address destination-
wildcard} {any|destination-port/port-range
} [dscp number|precedence number] [match-
all time-range-name] [time-range time-
range-name]
110
Dell PowerConnect 55xx Systems User Guide
Description
Sets conditions to
allow a packet to pass
a named IP access list
( in access list
configuration mode).
The list of protocols is
found above.