Dell PowerConnect 5524P User Manual page 244

Configuring ARP Using the CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the ARP pages.
Table 9-36. ARP CLI Commands
CLI Command
arp ip_addr mac_addr
{[gigabitethernet|tengigabit
ethernet] port-number|vlan
vlan-id|port-channel LAG-
number}
no arp ip-address
arp timeout seconds
clear arp-cache
show arp
show arp configuration
The following is an example of the CLI commands:
console(config)# arp 198.133.219.232 00-00-0c-40-0f-bc
console(config)# arp timeout 12000
console(config)# exit
console# show arp
ARP timeout: 12000 Seconds
Interface
---------
gi1/0/11
gi1/0/12
244
Dell PowerConnect 55xx Systems User Guide
IP Address
----------
10.7.1.102
10.7.1.135
Description
Adds a permanent entry in the ARP
cache.
Removes an ARP entry from the ARP
Table.
Configures how long an entry remains in
the ARP cache. This command can be
used in Global Configuration mode for all
interfaces, or in Interface Configuration
mode for a specific interface.
Deletes all dynamic entries from the ARP
cache
Displays entries in the ARP Table.
Displays the global and interface
configuration of the ARP protocol
HW Address
----------
00:10:B5:04:DB:4B
00:50:22:00:2A:A4
Status
------
dynamic
static