Dell PowerConnect 5524P User Manual page 108

Source Port (0 - 65535) — Enter the TCP/UDP source port. Enter
–
either Single, Range or select Any to include all ports.
– Destination Port (0 - 65535) — Enter the TCP/UDP destination port.
Enter either a Single, Range or select Any to include all ports.
– Source IP Address — Enter the source IP address to which addresses
in the packet are compared.
Wildcard Mask —In addition to the Source MAC address, you
•
can enter a mask that specifies which bits in the source address are
used for matching and which bits are ignored. A wildcard of
0.0.0.0 means the bits must be matched exactly in addition to the
IP source address; ff.ff.ff.ff means the bits are irrelevant. Any
combination of 0s and ffs can be used.
Any — Check to indicate that the source address is not matched.
•
– Dest. IP Address — Enter the destination IP address to which
addresses in the packet are compared.
• Wildcard Mask —In addition to the Destination MAC address,
you can enter a mask that specifies which bits in the source
address are used for matching and which bits are ignored. A
wildcard of 0.0.0.0 means the bits must be matched exactly in
addition to the IP destination address; ff.ff.ff.ff means the bits are
irrelevant. Any combination of 0s and ffs can be used.
• Any — Check to indicate that the destination address is not
matched.
TCP Flags — To use TCP flags, check the TCP Flag checkbox and
–
then check the desired flag(s).
– ICMP — Specifies an ICMP message type for filtering ICMP packets.
This field is available only when ICMP is selected in the Protocol
field. The following options are available:
Select from List — Select an ICMP type from the list.
•
• ICMP Type — Enter the ICMP type.
• Any — Check to use all ICMP types.
108
Dell PowerConnect 55xx Systems User Guide