Dell PowerConnect 5524P User Manual page 372

IPv6 Address Type — When the server supports IPv6, this specifies
–
the type of static address supported. The possible options are:
• Link Local — A Link Local address that is non-routable and used
for communication on the same network only.
• Global — A globally unique IPv6 address; visible and reachable
from different subnets.
Link Local Interface — When the server supports an IPv6 Link Local
–
address, this specifies the Link Local interface. The possible options
are:
• None — Disable the ISATAP tunnel.
• ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
– IP Address — Enter the receiver's IP address.
4 Enter the fields:
Syslog Port Number — Port to which SYSLOG message are sent.
–
– Maximum Header Size (Bytes) — Maximum number of bytes that
can be sent to the receiver in a single sample datagram (frame).
Adding an sFlow Receiver Using the CLI Commands
The following table summarizes the CLI commands for adding an sFlow
receiver.
Table 9-73. sflow Receiver CLI Commands
CLI Command
sflow receiver index {ipv4-
address|ipv6-address|hostname}
[port port] [max-datagram-size
bytes]
no sflow receiver index
show sflow configuration
[port_id]
372
Dell PowerConnect 55xx Systems User Guide
Description
Defines an sFlow receiver.
Use the no form of this command to
remove the definition of the receiver.
Displays the sFlow configuration for
ports that are enabled for Flow
sampling or Counters sampling.