Configuring LLDP Port Settings Using CLI Commands
The following commands are used to configure LLDP on ports.
Table 17-2. LLDP Port Settings CLI Commands
CLI Command
lldp transmit
no lldp transmit
lldp receive
no lldp receive
lldp optional-tlv tlv1 [tlv2
... tlv5]
The following is an example of the CLI commands:
console(config)# interface gi1/0/1
console(config-if)# lldp transmit
console(config-if)# lldp receive
console(config-if)# lldp optional-tlv port-desc
Description
Enables transmitting LLDP on an
interface.
Use the no form of this command to stop
transmitting LLDP on an interface.
Enables receiving LLDP on an interface.
Use the no form of this command to stop
receiving LLDP on an interface.
Specifies which optional TLVs
from the basic set should be
transmitted
Dell PowerConnect 55xx Systems User Guide
539