Dell PowerConnect 5524P User Manual page 390

Configuring Protected Ports Using CLI Commands
The following table summarizes the CLI commands for configuring
protected ports.
Table 10-4. Protected Ports CLI Commands
CLI Command
switchport protected-port
no switchport protected-port
switchport community
community
no switchport community
show interfaces protected-
ports[gigabitethernet|tengiga
bitethernet] port-number
The following is an example of the CLI commands:
console(config)# interface gi1/0/3
console(config-if)# switchport protected-port
console(config-if)# switchport community 1
390
Dell PowerConnect 55xx Systems User Guide
Description
Isolates Unicast, Multicast, and Broadcast
traffic on a port at Layer 2 from other
protected ports on the same switch.
Use the no form of this command to
disable protection on the port.
Associates a protected port with a
community
Use the no form of this command to
return to default.
Displays protected ports configuration.