Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the SNTP Interface Settings pages.
Table 9-11. SNTP Interface Settings CLI Commands
CLI Command
sntp client enable
{[[gigabitethernet|tengigabitethern
et] port-id|vlan vlan-id|port-
channel LAG-number]}
no sntp client enable
{[[gigabitethernet|tengigabitethern
et]port-number|vlan vlan-id|port-
channel LAG-number]}
sntp client enable
no sntp client enable
show sntp configuration
Dell PowerConnect 55xx Systems User Guide
Description
Enables the SNTP client on an
interface in Global
Configuration mode.
Use the no form of this
command to disable the SNTP
client.
Enables SNTP client on an
interface in Interface
Configuration mode.
Use the no form of this
command to disable the SNTP
client.
Shows the configuration of the
Simple Network Time Protocol
(SNTP).
185