Dell PowerConnect 5524P User Manual page 257

– Rule Priority (1-65535) — Enter the rule priority. Rules are applied to
packets according to their priority. These can be viewed in the Profile
Rules: Summary page.
Management Method — Select the management method to which
–
the access profile is applied. Users using this management method are
authenticated using this access profile. The possible options are:
• All — The access profile is applied to all management methods.
• Telnet — The access profile is applied to Telnet users.
Secure Telnet (SSH) — The access profile is applied to SSH
•
users.
• HTTP — The access profile is applied to HTTP users.
• Secure HTTP (HTTPS) — The access profile is applied to
HTTPS users.
• SNMP — The access profile is applied to SNMP users.
– Interface — Check the fields and select the interface type to which
the rule applies.
– Enable Source IP Address — Check this parameter to restrict access,
based on the source IP address. When this field is not selected, the
source IP address cannot be entered into a configured rule.
Supported IP Format — Select whether the IPv4 or IPv6 format is
–
supported for the source IP addresses.
– Source IP Address — Enter the interface source IP address for which
the rule applies. This is an optional field and indicates that the rule is
valid for a subnetwork.
Network Mask — Enter the IP subnetwork mask if Supported IP
–
Format is IPv4.
– Prefix Length — Enter the number of bits that comprise the source IP
address prefix, or the network mask of the source IP address.
Action — Select whether to permit or deny management access to the
–
defined interface. The possible options are:
• Permit — Permits access to the device.
• Deny — Denies access to the device.
Dell PowerConnect 55xx Systems User Guide
257