Dell PowerConnect 5524P User Manual page 518

Static — Displays available static ports/LAGs. These port/LAGs can
–
be included or excluded from the Multicast groups, as described
below.
– Current — Displays status of ports/LAGs, as actually applied, in the
Multicast group.
Managing LAGs and Ports Attached to Multicast Routers Using CLI Commands
The following table summarizes the CLI commands for managing LAGs and
ports attached to Multicast routers as displayed on the Bridge Multicast
Forward All page.
Table 16-4. Managing LAGs and Ports Attached to Multicast Routers CLI Commands
CLI Command
show bridge multicast filtering
vlan-id
bridge multicast forward-all
{ |
add remove
{
[gigabitethernet|tengigabitethe
rnet] interface-list
channel LAG-number-list
The following is an example of the CLI commands:
console(config)# interface vlan 1
console(config-if)# bridge multicast forward-all add
gi1/0/3
console(config-if)# end
console# show bridge multicast filtering 1
Filtering: Enabled
VLAN:
Port
-------
gi1/0/11
gi1/0/12
gi1/0/13
518
Dell PowerConnect 55xx Systems User Guide
}
|
port-
}
Forward-All
Static
-----------------
Forbidden
Forward
-
Description
Displays the Multicast filtering
configuration.
Enables forwarding of all Multicast
packets on a port.
Use the no form of this command to
return to default.
Status
-----------
Filter
Forward(s)
Forward(d)