Dell PowerConnect 5524P User Manual page 59

• The IP address to be assigned to the VLAN 1 interface through which
the switch is to be managed (by default, every external and internal
port is a member of the VLAN 1)
• The IP subnet mask for the network
• The default gateway (next hop router) IP address for configuring the
default route
2 Boot the Master unit. The system automatically prompts you to use the
Setup Wizard.
The Setup Wizard displays the following information:
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial
switch configuration and gets you up and running
easily and quickly. You can skip the Setup Wizard
and enter CLI mode to manually configure the
switch. The system will prompt you with a default
answer; by pressing Enter, you accept the default
value.
You must respond to the next question to run the
Setup Wizard within 60 seconds, otherwise the
system will continue with normal operation using
the default system configuration.
Would you like to enter the Setup Wizard (you must
answer this question within 60 seconds)? (Y/N)
3 Enter [Y] to run the wizard. If you enter [N] or if you do not respond
within 60 seconds, the Setup Wizard automatically exits and the CLI
console prompt appears.
If you enter [Y] the wizard provides interactive guidance through the
initial switch configuration.
The following information is displayed:
You can exit the Setup Wizard at any time by
entering [ctrl+Z].
The system is not set up for SNMP management by
default.
Dell PowerConnect 55xx Systems User Guide
59