Table 35: Show Ldp Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide
NOTE: The mpls keyword is optional and is provided for compatibility with non–E
Series implementations.
Table 35 on page 322 lists the show ldp command output fields.
Meaning

Table 35: show ldp Output Fields

322
Monitoring LDP
Field Name Field Description
LSR ID IP address of label-switched router
FEC Deaggregation State of FEC deaggregation, on or off
Egress label Type of label advertised for the LSR that is the egress router for
the prefix, implicit null, explicit null, or a non-null label
Label distribution control Label distribution control mode used by LDP for label distribution,
mode independent control, or ordered control
LDP session retry Configured values for the number of LDP session retry attempts
and the retry interval
LDP session hold time Configured value for the LDP session hold time
LDP session keepalive Interval at which LDP sends session keepalive messages, in seconds
interval
LDP targeted-hello hold LDP targeted-hello hold time, in seconds
time
LDP targeted-hello interval LDP targeted-hello interval, in seconds
Topology Driven LSP Status of topology-driven LSP, enabled or disabled
LSPs used for IP forwarding LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LDP proto stats LDP protocol statistics
totalPeersDiscovered Number of LDP peers discovered
totalAdjacenciesEstablished Number of LDP adjacencies established
totalSessionsEstablished Number of LDP sessions established
totalFECElements Number of FEC elements
totalFECs Number of FECs
totalInLabels Number of in labels (sent to upstream neighbor)