Table of Contents
Advertisement
M-series and MX-series Devices
394
NOTE: For devices running JUNOS Release 9.5 and later, admission controller settings
will be available in the device editor only when the policy-management mode is in the
in-device mode. By default, admission controller settings can be created only in the
Policy Manager and Object Manager.
Table 224: Admission Controller Configuration Details
Task
Configure an admission
controller for a border
signaling gateway (BSG).
Configure admission control
settings for dialogs.
Configure admission control
settings for out-of-dialog
transactions.
Configuring Session Policy Decision Function (NSM Procedure)
To configure session policy decision function in NSM:
Your Action
1.
Click Add new entry next to Gateway.
2.
Click Admission Controller next to gateway.
3.
In the Name box, enter the identifier for the BSG.
4.
In the Comment box, enter the comment.
5.
From the Service Interface list, select the name and logical
unit number of the Multiservices PIC or DPC.
6.
Click Admission Control next to gateway.
7.
Click Add new entry next to Admission Control.
8.
In the Name box, enter the name of the admission controller.
9.
In the Comment box, enter the comment.
1.
Click Dialogs next to admission-control.
2.
From the Maximum Concurrent list, select the maximum
number of concurrent dialogs. 0 causes all calls to be
rejected.
Range: 0 through 100,000
3.
From the Committed Attempts Rate list, select the maximum
number of attempts per second to initiate a dialog.
Range: 0 through 100
4.
From the Committed Burst Rate list, select the maximum
number of dialogs allowed to burst above the committed
rate and still be accepted.
1.
Click Transactions next to admission-control.
2.
From the Maximum Concurrent list, select the maximum
number of concurrent transactions. 0 causes all calls to be
rejected.
Range: 0 through 50000
3.
From the Committed Attempts Rate list, select the maximum
number of attempts per second to initiate an out-of-dialog
transaction.
Range: 0 through 1500
4.
From the Committed Burst Rate list, select the maximum
number of transactions allowed to burst above the
committed rate and still be accepted.
Range: 0 through 3000
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?