Clearing Ip Routes; Clearing Ip Interfaces - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

Clearing IP Routes

The router enables you to clear the specified routing entries from the routing table.
You must specify the IP address prefix and the mask of the IP address prefix to clear
specific routes. You can later reinstall the routes you have cleared.
clear ip routes
ip refresh-route

Clearing IP Interfaces

The router enables you to clear the counters on one or more specified IP interfaces.
clear ip interface
Use to remove the IP configuration from an interface or subinterface and disable
IP processing on the interface.
Example
host1(config-if)#no ip interface
See no ip interface
Use to clear specified IP routes according to an IP prefix or a VPN routing and
forwarding (VRF) table.
Use an asterisk (*) to clear all dynamic routes from the routing table.
Example
host1#clear ip routes *
There is no no version.
See clear ip routes
Use to enable the owning protocols (BGP, IS-IS, OSPF) to reinstall routes removed
from the IP routing table by the clear ip routes command.
Example
host1#ip refresh-route
There is no no version.
See ip refresh-route
Use to clear a specified IP interface.
Example
host1#clear ip interface pos 2/0
Chapter 1: Configuring IP
45
IP Routing