Split Horizon; Equal-Cost Multipath; Applying Route Maps; Before You Run Rip - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
You can use the ip summary-address command to specify routes that RIP will
Static Summary
summarize.
Example

Split Horizon

Split horizon is a mechanism to aid in preventing routing loops when distance-vector
routing protocols such as RIP are employed in broadcast networks. When split horizon
is enabled, the router cannot advertise information about routes on an interface from
which the information originates. Split horizon is enabled by default on the router.
You can disable split horizon and enable poison reverse routing updates that advertise
routes originating on the interface, but for each of these routes the metric is set to
infinity to explicitly advertise that these networks are not reachable.

Equal-Cost Multipath

RIP supports equal-cost multipath (ECMP) and installs into the routing table multiple
entries for paths to the same destination. Each of these multiple paths to a given
destination must have the same cost as the others, but a different next hop.

Applying Route Maps

You can apply a policy to redistributed routes with the route-map command. See
JUNOSe IP Services Configuration Guide, for more information about route maps. You
can use the table-map command to apply a route map to RIP routes that are about
to be added to the IP routing table.

Before You Run RIP

At least one IP address must be configured on your router for RIP to run.

Configuration Tasks

To configure RIP:
1.
2.
3.
210
Before You Run RIP
host1(config-router)#ip summary-address 4.4.0.0 255.255.0.0 5
host1(config-router)#ip summary-address 4.3.0.0 255.255.0.0 6
Create a RIP process by enabling RIP.
host1(config)#router rip
(Optional) Configure the global RIP version. RIPv1 is used by default.
host1(config-router)#version 2
(Optional) Do one of the following:
Associate a network with a RIP routing process and optionally configure RIP
for the network.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IGP - CONFIGURATION GUIDE V11.1.X and is the answer not in the manual?

Questions and answers

Table of Contents