Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 204

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
show ipv6 static
180
Monitoring IPv6
Valid lifetime Amount of time in seconds that the router advertises the
IPv6 prefix as valid
preferred lifetime Amount of time in seconds that the router advertises the
specified IPv6 prefix as preferred
Example 1
host1#show ipv6 routers
Router FE80::83B3:60A4 on FastEthernet2/0, last update 3 min
Hops 0, Lifetime 6000 sec, AddrFlag=0, OtherFlag=0
Reachable time 0 msec, Retransmit time 0 msec
Prefix 3FFE:C00:8007::800:207C:4E37/96 autoconfig
Valid lifetime -1, preferred lifetime -1
Router FE80::290:27FF:FE8C:B709 on FastEthernet2/1, last update 0 min
Hops 64, Lifetime 1800 sec, AddrFlag=0, OtherFlag=0
Reachable time 0 msec, Retransmit time 0 msec
Example 2
host1#show ipv6 routers conflicts
Router FE80::203:FDFF:FE34:7039 on FastEthernet1/0, last update 1 min,
CONFLICT
Hops 64, Lifetime 1800 sec, AddrFlag=0, OtherFlag=0
Reachable time 0 msec, Retransmit time 0 msec
Prefix 2003::/64 onlink autoconfig
Valid lifetime -1, preferred lifetime -1
See show ipv6 routers
Use to display the status of static routes in the routing table.
You can specify an IP mask that filters specific routes.
Field descriptions
Prefix IP address prefix
Length Prefix length
Next Hop IP address of the next hop
Dst Administrative distance of the route
Met Number of hops
Interface Interface type and interface specifier
Example
host1# show ipv6 static
Prefix/Length
-------------------- -------------------- ------- ------------------
NextHop Dst/Met Interface