Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 239

default-information originate
default-metric
disable
disable-dynamic-redistribute
Use the no version to restore the default value, 10 seconds.
See debounce-time
Use to enable RIP to advertise a default route (0.0.0.0/0) if the default route exists
in the IP routing table.
If the default route does not exist, you must configure it using the ip route
command, or specify the always keyword. The always keyword causes RIP to
always advertise the default route, and creates it if it is not present in the IP
routing table.
Example
host1(config-router)#default-information originate
Use the no version to disable advertisement of the default route.
See default-information originate
Use to configure RIP to apply this metric for redistributed routes on all
subsequently created interfaces.
Configuring a default metric lowers the priority of the routes.
Use a metric in the range 1 – 16.
Example
host1(config-router)#default-metric 5
Use the no version to restore the default value, 0.
See default-metric
Use to disable RIP processing.
Example
host1(config-router)#disable
Use the no version to enable RIP processing.
See disable
Use to halt the dynamic redistribution of routes that are initiated by changes to
a route map.
Dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
Chapter 4: Configuring RIP
215
Configuration Tasks